##***********************************************************
## File:		Accumulator user constraints file
##
##
## Created:	06/03/04 AV
##
##***********************************************************

## -------------------------------------------------
## The format for this file is as follows:
## NET "name_of_the_signal" LOC = PXX; 
## where XX is the PIN name (from datasheet)
## and name_of_the_signal is the name of the 
## signal you want to map out to a pin of the chip
## For instance, if switch no.5 uses pin 10, therefore:
##
## NET "name_of_signal" LOC = P10;
##
## -------------------------------------------------
#PACE: Start of Constraints generated by PACE

#PACE: Start of PACE I/O Pin Assignments
NET "an<0>"  LOC = "E13"  ; ##an4
NET "an<1>"  LOC = "F14"  ; ##an1
NET "an<2>"  LOC = "G14"  ; ##an2
NET "an<3>"  LOC = "D14"  ; ##an3


NET "cathodes_out<0>"  LOC = "E14"  ; ##CA
NET "cathodes_out<1>"  LOC = "G13"  ; ##CB
NET "cathodes_out<2>"  LOC = "N15"  ; ##CC
NET "cathodes_out<3>"  LOC = "P15"  ; ##CD
NET "cathodes_out<4>"  LOC = "R16"  ; ##CE
NET "cathodes_out<5>"  LOC = "F13"  ; ##CF
NET "cathodes_out<6>"  LOC = "N16"  ; ##CG

NET "clk"  LOC = "T9"  ; 
NET "data_in<0>"  LOC = "K13"  ; ##switch 07
NET "data_in<1>"  LOC = "K14"  ; ##switch 06
NET "data_in<2>"  LOC = "J13"  ; ##switch 05
NET "data_in<3>"  LOC = "J14"  ; ##switch 04

NET "reset"  LOC = "L14"  ; ## BTN 3
NET "user_set"  LOC = "L13"  ; ## BTN2 


#PACE: Start of PACE Area Constraints

#PACE: Start of PACE Prohibit Constraints

#PACE: End of Constraints generated by PACE